Welcome to Qingdao Zhongye Yufeng Tape Co.,Ltd. Official Website!

 admin@yuphengbelt.com

 +86-532-86728090

中文

CONTACT

Qingdao Zhongye Yufeng Tape Co.,Ltd.

Add:No.158,Jiangshan Road,ETDZ,Qingdao,Shandong,China.

Tel:+86-532-86728090

Email:admin@yuphengbelt.com

How to do when bucket machine conveyor belt sprinkle material

Number of visits: Date:2017-4-12


(1) at the transfer point of the sprinkle material: transfer point at the sprinkler is mainly in the hopper, guide trough, etc.. Such as belt conveyor serious overload, belt conveyor conveyor tarpaulin rubber skirt damage, guide groove at the steel plate design distance from the belt rubber skirt longer material to the material out of the trough. The above situation can be in the control of transport capacity, strengthen the maintenance on the solution.
(2) When the concave section of the belt is vacant, the belt is vacant when the radius of curvature of the concave section is small. At this time, the belt becomes a change in the groove, since the belt has left the trough idler group, The groove angle becomes smaller, so that part of the material spilled out. Therefore, in the design phase should be used as much as possible a large radius of curvature to avoid such a situation. Such as in the mobile mechanical loading machine, heap reclaimer equipment in order to shorten the tail car and the concave section of this design into a non-circular transition interval, when the belt width is relatively easy to use when the smaller scavenging material.
(3) when the deviation of the sprinkle material: belt deviation when the material is because the bucket conveyor belt belt in the operation of the two edge height changes, while high, while the other side low, the material from the low side of the Caesar Out, the method is to adjust the deviation of the belt.

TypeInfo: Industry news

Keywords for the information: