Welcome to Qingdao Zhongye Yufeng Tape Co.,Ltd. Official Website!

 admin@yuphengbelt.com

 +86-532-86728090

中文

CONTACT

Qingdao Zhongye Yufeng Tape Co.,Ltd.

Add:No.158,Jiangshan Road,ETDZ,Qingdao,Shandong,China.

Tel:+86-532-86728090

Email:admin@yuphengbelt.com

Precautions for Use of Conveyor Belts

Number of visits: Date:2016-10-11

In the use of conveyor belt transport and storage should note the following points:
In this case,
1, Conveyor belt should be kept clean during transportation and storage, avoid direct sunshine, rain and snow leaching, prevent material contact with rubber, such as acid, alkali, oil and organic solution, and 1 meter away from heat source.
2, the storage temperature should be kept in the Treasury at -15 ℃ ~ +40 ℃ between the relative humidity should be maintained at between 50% -80%.
In this case,
3, storage in the conveyor belt to be placed in rolls, shall not be folded, placed during the quarterly turn once.
In this case,
4, the conveyor speed should not be greater than 5.0 m / s, transport block degrees, wear-resistant materials and the use of fixed plow-type discharge device should be used as low speed. Exceeding the specified speed will affect the tape service life.
In this case,
5, the conveyor drum diameter and the relationship between the layout of the conveyor belt, transmission roller matching roller groove angle and the requirements should be based on the transport design requirements, a reasonable choice.
In this case,
6, in order to reduce the impact of material on the account and wear and tear, feeding direction should be along the running direction of the tape; material falling on the tape should be reduced as much as possible; feeding port should avoid the roller or roller above; The receiving section should be shortened the roller spacing and take buffer measures. In order to prevent scraping tape, block device, scraper cleaning device and the discharge device and the tape should be part of the contact with the hardness of the appropriate rubber plate, do not use the tape layer with a tape head.
In this case,
7, conveyor belt in use should pay attention to the following:
In this case,
A to avoid the roller is covered by the material, resulting in rotation is not working to prevent the leakage of material between the roller and the tape in the card, pay attention to the active part of the lubrication, but not oil conveyor belt.
In this case,
B to avoid starting with a load.
In this case,
C tape deviation occurs, should take timely measures to correct.
In this case,
D tape local damage should be promptly repaired, so as not to expand.
In this case,
E Avoid the tape from the rack, pillars or block material block, to prevent breakage rip.
In this case,
8, the joint strength retention rate:
In this case,
(1) mechanical method: with the buckle connection is equivalent to the strength of the conveyor belt 28% -45%
In this case,
(2) natural cold stick method: with cold glue adhesive equivalent to the strength of the conveyor belt 40% -55%
In this case,
(3) thermal curing method: mechanical thermal curing adhesive equivalent to the strength of the conveyor belt 60% -80%
 

TypeInfo: Industry news

Keywords for the information: